Floor bricks have different water absorption rates
The interior tiles are divided into wall tiles and floor tiles according to the paving locations. Strictly speaking, the wall tiles are pottery products, and the floor tiles are usually porcelain products. Their physical properties are different. There is a big difference between the selection of clay ingredients and the firing process. The water absorption rate of wall tiles is about 10%, and the specific water absorption rate is only 1% of floor tiles are several times higher. The floor of the bathroom and kitchen should be laid with low water absorption floor tiles, because the ground will often use a lot of water to wash, so that tiles can not be affected by water vapor, do not absorb stains.
Moen faucet     Yilibao Ceramics      Carrie bathroom
Wall tiles are made of glazed ceramics and have a high moisture content. The back of the wall tiles is generally rough, which also helps the adhesive to attach the wall tiles to the wall. Tiles are not easily affixed on the walls. Wall tiles used on the ground will absorb too much water and become difficult to clean. It can be seen that walls and floor tiles cannot be mixed.
Shop before leveling
The foundation should be cleaned before tiling, for example, lime plaster, latex paint, wallpaper, etc. on the wall, or dirt on the ground, must be cleaned, otherwise the cement mortar and the grass-roots layer will not be firmly bonded; in addition, if the wall itself There are cracks that should be properly treated before being allowed to be tiled so as to prevent cracking or shedding of the wall tiles in the future when the basic structure cracks become large; and also for the floor and wall surfaces where the flatness or verticality gap is too large. The mortar is leveled.
The order of laying stress
Posted floor tiles should be from the inside to the outside, such as the slope of the ground or there are leaks children, should pay attention to the direction of the drainage slope; wall tiles should be laid from the bottom, for the sake of beauty, the bottom of the brick should be posted. After pressing the tiles, press the floor tiles. When there are half bricks, you should try to place them below. In addition, a wall cannot be attached to the top at a time to prevent the tile from being heavy and causing it to fall.
Wall tiles should be fully soaked
Wall tiles have a high moisture content and must be considered when pasting. The tile base should be fully moistened before it is tiled, and ceramic tiles should also be soaked in water for at least 20 minutes before use. Otherwise, the moisture in the mortar is rapidly absorbed by the dried substrate and tiles and condenses quickly, which affects the fastness of the bond. Wall tiles will also absorb moisture from the cement so that the cement does not function as an adhesive. In addition, the water absorption rate of each type of wall tile is not the same, which depends on the experience to grasp.
Tiles Tiles Floor Tiles Cement Latex Paint Wallpaper Decorative Paints Floor Tiles Kitchen Tiles Bathroom Tiles Bathroom Tiles Bathroom Tiles Tile Tiles Kitchen Tiles Ld Tiles
The apron sink front protrudes slightly from the supporting cabinets, eliminating countertops that cause users to lean forward and over-stress. At the same time, this practical design helps prevent cabinet damage. The apron sink is easy to install following this video. Made of high quality stainless steel, this handmade sink is not only anti-corrosion and anti-scratch,but also strong and durable.Its Modern and stylish appearance fits into any style of kitchen.
Apron Sink,Copper Farmhouse Sink,Undermount Farmhouse Sink,Granite Sink
JIANGMEN MEIAO KITCHEN AND BATH CO.,LTD , https://www.jmmeiaogroup.com