Daily maintenance
1 Wipe the device with a soft cotton cloth every day to keep it clean.
2 Check the gas source triple piece before starting the machine every day. When the oil level is insufficient, add the lubricating oil and drain the water.
3 Clean the fluff in the dust box every day to ensure good ventilation and make the equipment perform the best drying effect.
2. Monthly maintenance
1 Open the rear cover and clean the inside of the machine with a soft cotton cloth.
2 Fill the moving parts such as bearings with lubricant to reduce friction.
3 Check the belt tension and adjust the pulley.
4 Sturdy parts that are easy to cause looseness and fall off after vibration, including electrical lines, rocker arms of doors, pipe joints, etc.
3. Annual maintenance
1 Check that the mounting bolts on the base are loose and strong.
2 Check the tension of the support spring connection and adjust it at the time.
3 Check the grounding of the equipment and ensure it is reliable.
4 Check the flexibility of the control of the computer board, the wind wheel, and the heat exchanger.
5 Meters such as thermometers on the equipment are sent to the local technical supervision bureau for measurement.
4, dryer bearing maintenance
The shaft of the bearing crusher bears the full load of the negative machine, so good lubrication has a great relationship with the bearing life. It directly affects the service life and operation rate of the machine. Therefore, the injected lubricant must be cleaned and the seal must be good. The main oil filling part of the machine (1) rotating bearing (2) roll bearing (3) all gears (4) movable bearing, sliding plane.
1. The newly installed tires are prone to loosening and must be inspected frequently.
2. Pay attention to whether the work of all parts of the machine is normal.
3, pay attention to check the wear level of wearable parts, always pay attention to replace the worn parts.
4. The plane of the undercarriage of the movable device should be removed from dust and other things to prevent the movable bearing from moving on the chassis when the machine encounters materials that cannot be broken, resulting in serious accidents.
5, the bearing oil temperature rises, should stop immediately to check the reasons to eliminate.
6. If there is impact sound when the rotating gear is running, it should be stopped and checked immediately and eliminated.
Quartz glass is made by melting a variety of pure natural quartz (such as crystal, quartz sand, etc.). The coefficient of linear expansion is extremely small, which is 1/10-1/20 of ordinary glass, and has good thermal shock resistance. It has high heat resistance, often used at temperatures between 1100 and 1200 degrees Celsius, and short-term temperatures of up to 1400 degrees Celsius. Quartz glass is mainly used in laboratory equipment and refining equipment for special high-purity products. Because of its high spectral transmission, it is not damaged by radiation (other glass will be dark after being irradiated by radiation), so it is also an ideal glass for spacecraft, wind tunnels and spectrophotometer optical systems.
Quartz Glass,Optical Fiber Quartz Glass Rod,Glass Measuring Beaker,Quartz Glass Slid
Dongguan Haikun New Material Co., Ltd. , https://www.hkceram.com