In the use of latex paint, due to the quality of the latex paint itself and the brushing problems, such “common diseases†often appear on latex paint walls:
>>> Links: 5 Ways to Renovate Walls
Powdering
Cause: Due to the poor weather resistance of some of the main components of low-grade latex paints, if the walls are not treated beforehand or are applied at low temperature, the emulsion paint will not form a good film. This phenomenon will happen soon after the paint. Sometimes too much water when brushing, etc. can also cause the paint to become powdery.
Prevention: First of all, the wall should be completely dealt with, with a special wall putty brushing the wall surface and to be smooth; then first with water or oily back cover primer painted again, and then painted twice the topcoat. In addition, latex paint must be mixed with water in accordance with the prescribed ratio, and avoid construction at low temperatures.
Discoloration and fading
Causes: Some wall temperatures are too high, long hours of sunshine, or water-soluble salts crystallize on the surface of the wall and cause discoloration and discoloration of latex paints; some walls contain too high alkalinity, which affects the weak alkaline resistance The pigments or resins cause discoloration and discoloration; while others are improperly constructed and applied at the same time as the polyurethane paints. The TDI ingredients contained in the paint will discolor the latex paint.
Prevention: As the first situation is relatively rare, you can consult the relevant personnel; for the second case, refer to the treatment of the powder; In order to avoid the third situation, both the latex paint and the polyurethane paint should not be used at the same time. Apply latex paint two days later (at 25 degrees Celsius) or paint thoroughly after the latex paint has dried completely (7 days at 25 degrees Celsius).
Peeling and peeling
Cause: This phenomenon is caused by the moisture inside the wall to make the paint film out of the wall, causing peeling. Of course, improper handling of the wall can also cause such problems.
Prevention: look before construction, if any leakage occurs, please promptly ask the relevant department to resolve it. If it is a new house, the phenomenon of evaporating water from the wall is unavoidable. Special treatment should be added. It is recommended that the walls be pretreated with a durable, waterproof, elastic putty, and then painted as usual. Peeling and shedding problems. In view of the above three conditions, in addition to special reasons, improper handling of the walls will cause problems of latex paint on one side or the other, so when you supervise the construction, you must allow the workers to clean the walls. Behave rashly, otherwise the consequences could be disastrous.
Wall construction paint latex paint new house
Linear High Bays,Garage Light Linear Highbay,Led Linear Highbay Light,High Lumen Linear High Bay Light
Fuonce Lighting , https://www.fuonce.com