Electrostatic precipitators are widely used in industries such as steel, electric power, and cement. The key component of the electrostatic precipitator is the anode plate. In order to ensure the installation of the anode plate of more than ten meters, the design is called a clip part as shown in Fig. 1. The clip is bent by a stamping piece of 1.5mm cold-rolled sheet as shown in Fig. 2. We have designed a manual simple bending tool in production practice, which is described below.
Bending tooling
The tooling consists of a fixed mold, a rotating shaft 1, a rotating shaft 2, a pressing handle, and a movable mold, as shown in FIG. The pressing shank is rotatable about a rotating shaft 1 fixed to the stationary mold, and the movable mold is rotatable about a rotating shaft 2 fixed to the pressing shank. There is a notch on the fixed mold, which can be inserted into the cold-rolled plate stamping part. The fixed-formed press-shaped part and the notch are cut and cut with a wire, and the fixed-formed pressed part and the movable mold surface are both hardened, leaving 1.6 mm between the moving molds. gap.
2. Bending operation steps
Lift the handle and insert the end of the workpiece into the fixed mold notch (see Figure 4) → press the handle and press the workpiece to a right angle (see Figure 5) → lift the handle, pull out the workpiece, and insert the workpiece into the fixed mold gap. (See Figure 6) → Press down the presser and press the other end of the workpiece into a right angle (see Figure 7). Operation Note: The shaft and the moving mold surface should be well lubricated to reduce wear and avoid over-heading.
3. Conclusion
Our company has used the tooling to process hundreds of thousands of products. The product has high dimensional accuracy, stable quality, meets design requirements, and has low labor intensity, which greatly improves work efficiency.
AI Splice Tape Crepe Paper is an Auto Insertion Machine Splice Tape made from high grade crepe paper materials. Crepe paper is one of the lightest paper and normally weights below 35g/m2. Using crepe paper materials, KDW has designed a lightweight yet durable splice tape. This AI Splice tape is capable of providing a good joint result with the Axial Radial Component Rolls. KDW is one of the trusted manufacturers that produce SMT and Auto Insertion Splice Products, Tools and other products that will help SMT and AI production process.
AI Splice Tape with 2 - 3 - 5 - 6 holes for Automatic Insertion (AI) system
AI Splice Tape 5 holes flange 3 holes
Rim Description: AI Splice Tape with 3 or 5 holes for Automatic Insertion (AI) system.
1. AI splice tape is special for AI (Auto-Insertion) machine, applicable to both axial components and radial components.
2. Easy to use and good quality.
Packing quantity
AI splice tape (with 2 holes) 2000pcs/roll
AI splice tape (with 3 holes) for both axial components and radial components 2000pcs/roll
AI splice tape (with 5 holes) 1000pcs/roll
AI splice tape (with 6 holes) 1000pcs/box
KDW-Brand> Quality> Price advantage> Complete> Service> your preferred!
AI Splice Tape Crepe Paper,AI Five Hole Crepe Splice Tape,AI Six Hole Crepe Splicing Tape,Six Hole Crepe Splice Tape
ShenZhen KDW Electronics Co.,Ltd , https://www.smtsplicetape.com