I. Substrate Handling Stealing Index: ★★★★★
Phenomenon: Before applying latex paint and paving wall tiles, be sure to do the substrate treatment. Some workers cut corners and cut materials in this regard during construction, and the unevenness caused uneven wall surface. After the paint is applied, there is a color difference. When the paint is applied, the paint is discolored and peeled off, or the ceramic tile is not firmly bonded.
Reminder: In the paving construction of wall tiles and floor tiles, we must pay attention to the fact that ceramic tiles cannot be directly laid on the surface of lime mortar, lime plaster, lime paper plaster, hemp stone mortar and latex paint, but the base layer must be treated cleanly. Can be laid behind. Bonding pastes used between tiles and substrates should be formulated in strict accordance with the construction standards and proportions, using the specified grades of cement and adhesive materials, and they cannot be randomly deployed. When applying latex paint, be sure to pay attention to whether the shading of the wall putty is even and smooth, whether the sanding and rolling are in place. In addition, pay attention to whether the latex paint is properly proportioned.
Second, the ground leveling sharks index: ★ ★ ★ ★ ★
Phenomenon: Some houses are not well-grounded and need to be re-leveled during the renovation. If the workers are not careful or intentionally sloppy, it will cause the problem of “more and more unevennessâ€, and the cement mortar used in construction will also greatly increase the ground load, causing hidden dangers to the safety of the building.
Reminder: Before doing leveling on the ground, you must first do a good job of the ground floor treatment, and then use cement mortar to level the ground. After the cement is dry, determine the flatness of the entire floor using a dedicated level ruler, and then proceed to the next step.
Third, small face processing jail workers index: ★ ★ ★ ★ ☆
Phenomenon: "Small face" is a small place that ordinary people can't see and can't pay much attention to, such as the upper edge of the door, the underside of the window board, the inside of the heating cover, etc. Some workers will cut corners here. It will even do nothing.
Reminder: Remember that there are 6 planes for any object. Don't ignore any details when checking the quality of the project.
Fourth, the wire wear pipe stealing index: ★ ★ ★ ★ ☆
Phenomenon: In the home improvement construction, almost all wires are put in PVC pipes and buried in the walls. After the wires were put into the PVC pipe, the owner couldn't see it at all, and it was difficult to replace it. If the worker is not careful in the operation, it will cause the wire to kink in the tube, causing electricity hazards. If workers cut corners, they will use wire with connectors or put several wires in the same PVC pipe.
Reminder: It is best for the owner to purchase the wires or specify the brand. Then supervise the worker's operation on the site, and check the power-on after installation. In addition, the decoration company must leave a "pipeline map." When the electrician had just buried the wires in the wall, he could number the walls and draw a floor plan. Then he used the strokes to draw the direction of the wires and the specific location of the wires, indicating the position on the floor, the ground and the adjacent wall. In particular, the position of the joints of the pipelines should be marked so that in the event of a fault, the line position can be found immediately.
Fifth, seam modification sharking index: ★ ★ ★ ★
Phenomenon: In some places where the wall meets the door and the window, and where the two different colors of paint are docked, it is also where the workers often perfunctory. We often see mixed paint between latex paint and wood, and various problems at the joints.
Reminder: The treatment of joints is very important. We must supervise the workers' construction. If there are two colors of paint on the wall facing each other, it is necessary to apply adhesive tape on the edge of the first color during construction, and then apply another color of paint on it, so that the construction is completed. After tearing off the tape, the entire seam can be very neat.
Sixth, the wall tick slotting index: ★ ★ ★ ☆
Phenomenon: The buried pipeline must be slotted on the wall and the ground in order to bury the pipeline. A few workers perform barbaric construction during the grooving operation, which not only damages the building load-bearing structure, but also may cause damage to other nearby pipelines.
Reminder: Before construction, we must reconfirm the direction and location of the pipeline with the construction team leader. For different wall structures, the requirements for slotting are not the same: the walls of the load-bearing wall in the house are not allowed to be slotted, and the wall with the insulating layer is easy to cause cracking on the surface after being slotted, and on the ground Slotting, but also be careful not to damage the floor, causing unnecessary trouble to the residents downstairs.
Seventh, wall and floor tile stealing index: ★ ★ ★
Phenomenon: Paving wall tiles and floor tiles are a highly technical process. If workers cut corners, they are most prone to problems such as empty tiles, missing seams, and cement and adhesives used for laying tiles. If the ratio is unreasonable, there will be problems such as shedding.
Reminder: According to the "Household Decoration Engineering Construction Specification" promulgated by the Ministry of Construction, the requirements for wall and floor tiles should be flat and solid, clear patterns, no dirt and paste marks, the surface color is basically the same, uniform seams, no cracks, out of angle And lack of edge, local emptying must not exceed 5% of the total.
Eight, wire connector stealing index: ★ ★ ☆
Phenomenon: When the electrician installs sockets, switches, and lamps, it does not wire according to the construction requirements. In particular, when the owner uses some electric appliances such as water heaters and air conditioners that consume large amounts of electricity, the switches and outlets cause heat and even burn, which brings great losses to the owners.
Reminder: In the construction supervision of the electrician in strict accordance with the operating procedures for construction, after all switches, sockets installed, must be the actual use to see if these parts have a fever.
Nine, the sewage pipeline stealing index: ★ ★
Phenomenon: During the renovation of the construction team, in order to save time, a large amount of concrete, sand, and concrete fragments are poured into the sewer. The direct consequence of this is a serious blockage of the sewer, causing the kitchen and toilet to run out of water due to poor water. Although some projects have no problems in the final acceptance, they always have problems with poor water.
Reminder: Strictly supervise the construction team and do not use the sewers as garbage paths. After the construction of the waterway is completed, all the basins, basins and bathtubs are filled with water, and then the water is discharged at the same time to see if the water is unobstructed and if there is any leakage of the pipeline.
Ten, wall painting sharks index: ★ ☆
Phenomenon: Latex paint is the most common wall decoration material. It can be painted, rolled or sprayed in specific construction. If the workers are not serious or perfunctory during construction, small color differences often occur. Especially with deeper emulsion paints, this problem is more likely to occur.
Reminder: Before the use of latex paint to add a certain amount of water, deployment of a good latex paint to be used up once. Paints of the same color are also best painted once. If the wall needs to be repaired after construction, the whole wall should be repainted again.
Beware of the above ten decoration kitten tired, easily save a fortune!
Decoration decoration company okay decoration materials brand home improvement decoration steps decoration materials knowledge
Full Spectrum LED Grow Lights
Full spectrum LED Grow Lights 600/900/1200W /2000W Double Chips LED Grow Lights Indoor Plants lamp for flowering and growing
Product Description
1. Comply with the safety requirements around the world
2. High power LED,Life 50,000 hours
3. Energy saving 80%,compared to sodium lamp sand metal halide lamps
4. Fan cooling,low temperature rise
5. A variety of LED chip synthesis spectrum.
6. Input: AC100~277V,PF >0.9
7. Recommended irradiation distance of 0.5 ~ 0.8m,Coverage 0.7m @ 6m2
8. Warranty:3 years
9. CE RoHS FCC.UL
How to Select the Best Grow Light for your Greenhouse?
The plant needs light to thrive cause the light is essental for photosynthesis.without it,plants can not make food.but light can also be too intense,too hot or last too long for growing healthy plants.plant growth accelerates with abundant light because more of the plant`s leaves have exposure,which means more photosynthesis.in the winter,days are not long enough,but many plants still need 12 hours or more of light per day.
Now,adding led grow lights to your greenhouse is an nice choice if you live in the north, and can not get enough daylight in winter.you might be take HID into consideration,cause it has high output and cover a wide area.but now,we providing you some dfferent.the newest type of grow lights use LED technology.
Provides Maximum Light Density and optimizing spectrum(410nm-740nm,white)
as we know that the plants need more light from the blue side of the spectrum during their seedling stage and when developing foliage and require light from the orange to red side of the spectrum while inblooming and fruiting phases. We adopting lastest intergrated COB technology, white , more red and blue PAR(410-740nm) per Watt than any other lighting fixture for the best color uniformity.
Dual Veg and Bloom for plant growth and bloom
the Led grow lights feature selectable VEG and BLOOM light spectrums to deliver maximum performance from seeding through the flower stage and finally harvest.
Increase yields and potency
using high quality lense that hyper-focus the lights on your canopy.the photons are beamed directly to the plants.this gives growers the ability to get greatest possible crop yield.
Reduce your costs with energy efficiency
energy-efficient cannabis grow lights cost between 40%-60% less to operate compared to HID lam year.
Led grow light also eliminate the needs for ballasts and reflectors while they minimize the cooling systems,accelerating your payback.you will see the electrical bills trimmed by approximately half,year after year.
Installs and operates simply
the input voltage is AC100V-240V,fit for the world standard,built-in power supply.do not need other equipment,just access to the Plug,the lamp will be work smoothly. The led grow lighting is small size,just few inches and easy to install.it is the good option for some greenhouse.
Long lifespan
using built-in quiet fans and the shutter in the wind,induced draftfrom all sides.runs with quiet. Useadvanced isolation power supply and soft start protection technology, to prevent the high voltage when turn on the light from damagingthe lamp body.
Our professional full spectrum LED grow lights are suitable for all the indoor plants and good for seeding, growth,flowering and fruiting stages of plants, increasing the harvest and Saving energy.
User manual:
1>Indoor and green house use only
2>Do not touch the surface when the power is on
3>Do not use it at the place where the water is dripping
4>Blue is good for vegetative and red is good for flowering and budding, customer can choose the ratio of the red and blue, which has wonderful efficacy for the plants
Our Advantages
Professional: we are professional LED Grow Lights and LED Aquarium Light manufactuer here in China, you will get Professional and High quality LED Grow Lights and LED aquarium lighting from us and get good guarantee.
Cost-effective Price: we don`t have the lowest price, but the grow lights and Aquarium Light you get from us really cost-effective, good quality & decent price.
Win-win situation: Long term business is our mission, we think you will agree with us if you are running a business, so we will provide good led aquarium grow lights and warming service to build a long-term business relationship with you
24/7 unlimted customer service: we are always here for you for your question, any question just email us or call us, we will do our best to help you all the way.
Long term warranty: Don`t worry about the quality and we guarantee you 3years warranty for all the LED Plant Grow Light and coral reef led aquarium light..
Best buying experience: you will get the tiptop serive you have ever had,just have a try and you`ll see.
Philizon Fulll Spectrum LED grow lights are perfect for green house applications and much more!
Full Spectrum Led Grow Lights,Full Spectrum Plant Grow Light,Full Spectrum Led Plant Grow Light,Full Spectrum Indoor Plant Grow Light
Shenzhen Phlizon Technology Co.,Ltd. , https://www.szledaquariumgrowlight.com
