Blanket acceptance checkpoints Blanket acceptance checklist

For the rough room, the owner may want to understand the most likely is the acceptance of the rough room, because this is the first step in the renovation. A good start means that half of the renovations are successful, but how many homeowners can really do a good job in the acceptance of rough houses? Next, Xiao Bian introduced the acceptance points of the embryonic embryo house and the acceptance considerations for the rough house.

Hair embryo house acceptance points

1, doors, windows

The door is the most easily forgotten place. After the owner happily opened the door with his key, he was most concerned with seeing what the house looked like. The appearance and appearance of the door were left behind. This process is absolutely undesirable. Now the houses are installed with anti-theft doors. After opening the door, you should carefully observe and touch the surface of the door by hand to see if it is flat and there are no scratches or areas that have been impacted. Look at the door frame visually, because the door frame is not correct. Will directly affect the use of your actual life in the future, but also should try to lock back and forth to see if the normal opening, closing, if you encounter problems to timely reflect the property to be replaced.

Today's homes use steel windows and use hollow glass. During acceptance, we must inspect the glass and window frames of each room and carefully look for any debris, water marks, scratches, or glass in the glass. There is water vapor; the window frame is not correct, whether the window is open and closed properly, whether it can reach 90 degrees when the window is opened, and whether the waterproof window is pasted out by hand or not, depends on whether the windows of each window are installed. All right.

2, wall, ground

In the acceptance of the rough house, the wall surface and the ground are the largest and most critical areas. We must check whether the walls of all rooms are flat or whether the floor of the kitchen or bathroom is empty. If the unevenness of the wall will cause a lot of trouble for the decoration in the future, the unevenness of the ground will also affect the later paving or laying of the floor. If there is a hollow area in the wall of the bathroom and the kitchen, it will be easy to fall off after the decoration is attached to the tile.

In order to avoid and early detection of these problems, we can use some lively, easy-to-use methods of earth testing to find a longer bar on the wall and see if the bar is attached to the wall, if there is 1 - The error of 2mm is within the scope of the national standard. If the error is large, the property must be hired to pick up the worker to rehash the wall. We can also take the book and use one of the 90-degree right angles against the corner to see if it is perpendicular to the 90-degree angle of Yin Yang. To see if there is an empty drum on the wall, you can use a small hammer to test and judge whether there is empty drum on the wall by sounding when you tap.

3, electricity

When checking the house, check whether there is electricity in each room. Each room has a simple light bulb to see if they are all normal. The outlets in each room must not be forgotten. It is not very expensive to sell simple electroscopes on the market. We can use test pencils to test whether each outlet has electricity. If you don't have a test pencil, you can use the soil method and use a mobile phone charger or hair dryer.

4, water

In the rough room, toilets and kitchens are well-routed water lines, but most of them have no taps. We can take a bucket of water and pour it into the pipeline to see if the water is blocked or not. If you hear the sound of the water, you can say that the water is very happy. The floor of the bathroom should be well waterproofed, but it is impossible to do a water-blocking test during the inspection because of the conditions. Therefore, we must let the decoration workers do a water-blocking test before the renovation and look for water leakage after 24 hours.

5, ventilation system

Ventilation systems are a big problem that can easily be overlooked during home inspections. Flues and exhaust ducts are places that are easy to leave hidden dangers for daily life.

Blank room acceptance considerations

1. When entering the house in the notice of acceptance of the new house, first check the evenness of the wall and whether there is any crack in the seepage.

2, rough room inspection room should check the doors and windows, balcony cracking phenomenon.

3, blank room inspection room should check the smooth flow of water and gas.

4, blank room inspection room should check the ground for empty shell, cracking situation.

5, blank room inspection room should check the water route inspection.

6, rough house inspection room should check the check of the contract on some facilities for acceptance.

7, blank room inspection room should check the height of the measurement floor, the meter digital meter records, the size of the shower room, etc.

Editor's summary: The acceptance points of the embryonic embryo house and the precautions for acceptance of the rough house are introduced here and I hope to be helpful to everyone. If you want to know more related information, you can pay attention to this website information.

New house acceptance notice

Press Tools

Battery press tools with jaws for press pipeline systems.

Battery gun:

RIDGID 310