The time spent on the ceiling will inevitably look old, and sometimes it will be found that the wall is blistering, cracking, or even peeling. At this time, we will repaint it.
Aopu kitchen ceiling
If you want to feel the fun of painting, do it yourself. Be sure to brush the ceiling, the edge of the lamp, and use the roller for a large area of ​​paint. If the corners and ceilings are to be brushed, they should start from the ceiling.
Step 1: Clear the wall. There is a small white powder on the wall, indicating that the salt in the wall is “precipitated†during the drying process of the cement. At this time, you can brush it off with a nylon brush or iron brush. After a few days of observation, it is determined that there is no longer a white powder. Precipitate, and wait for the cement wall to dry and flat, you can paint.
If the white powder on the surface of the cement wall is plentiful and continuously precipitated, after cleaning it, you can apply a primer on the surface of the wall to prevent salt erosion and the formation of wall cancer in the future; II Do not use oil paint or water-impermeable wallpaper within three months. Brushing or renovation. Step 2 In addition: Remove the peeling paint film.
Remove the peeling film with a knife or iron brush, and then use a sandpaper to polish the surface. Step 3 Demolition: Remove paste pasted wallpaper.
Step 4 Repair: Trim the surface. Fill the cracks in the pit with a batch cutter, wait until it is completely dry, and grind it with sandpaper.
Step 5: Treat wall lesions.
Step 6 Primer: Apply primer first. The "primer" coating is used exclusively for wall surfaces that do not require special treatment. For problematic walls, the "primer" that specializes in this particular problem must be selected for the problem.
Step seven finishes: paint again. It is generally used paint.
Step eight brush: brush from top to bottom. After the paint was evenly mixed with a wooden stick, the brushing process started from the ceiling and brushed again, so as not to cause the paint that had fallen from the smallpox to finish the finished wall.
Tips: Calculate the amount of paint Formula One: The total brushing area converted from the floor area Algorithm: Total paint area = four walls of paint + ceiling paint four walls of paint area = ground area multiplied by 2.8 ceiling paint area = floor area multiplied by 1 formula two : Estimated amount of paint on the repainted wall = Total painted area divided by the unit area Painted area Stucco walls Tips To increase the adhesion of the lime slurry, a small amount of salt may be added during the preparation of the mortar (usually 100 parts of quicklime plus 7 parts) salt). This brushed wall is not prone to dust.
If a 0.5% blue starch or blue ink is added to the slurry, the brushed walls can be made whiter. Several key issues for stucco walls:
1. To paint and decorate the newly painted paper gray wall, wait until the outer layer of lime is completely dry before proceeding. Otherwise, the effect of beautification will be caused by the appearance of flower spots on the wall.
2. During the process of brushing the lime slurry, the lime slurry should be continuously stirred, otherwise, the lime slurry will precipitate, and there will be different shades of light on the wall after brushing.
3, when painting, should master the principle of top-down, a set of brushstrokes, vertical brush, but also from the left to the right horizontal brush, but should pay attention, do not miss the pen.
4, in the dark old lime wall (excluding plastic white wall), including the spot more refreshing color on the wall, you should first use white gray water full brush again, until the dry white color refresh.
5. If the painted lime wall is no more than half a year old, add an acidic colored drywall powder. If the color is green, sky blue, etc.
6, when you paint the walls yourself, pay attention to operating safety.
Paint paint purchase construction acceptance three trees paint paint cement wallpaper decorative kitchen ceiling
The utility model provides an electronic igniter, which is characterized in that it is composed of a shell with an ignition port at the left end and a button port on it, an ignition tube connected with the ignition port at the left end of the shell, an ignition device fixedly connected with the button port, and a cable connected with the ignition device. The ignition device is composed of a rectangular shell and a button sliding connected with the upper end of the shell, The utility model is composed of a striker connected with the lower surface of the button, a power generation ceramic block fixedly connected with the bottom of the shell, a thimble connected with the upper surface of the power generation ceramic block, and a spring which is connected with the power generation ceramic block and sheathed outside the thimble. The electronic igniter has the characteristics of simple structure, safe and reliable, convenient operation, no need to use batteries, etc., which is not only economical and environmental protection, but also convenient for wide promotion.
Jet Flame Camping BBQ Outdoor Lighter,Outdoor Gas Lighter Torch,Refillable BBQ Gas Lighter
Shangqiu Zhengtu Hardware Technology Co,.Ltd , https://www.zlztlighter.com