Many people tend to buy second-hand housing to live, second-hand housing community is relatively mature, and the surrounding equipment is relatively complete, but second-hand housing renovation and new house decoration still have some differences, the following seven must not be forgotten.
1, on the demolition of the old
Second-hand housing renovation needs to remove old objects such as doors and windows. During the demolition process, we must first ensure safety, and we must also ensure that it is removed.
2, on the wall
Before 95 years ago, the walls of the house rarely used cement mortar. If the original floor had empty drums, it would be easy to crack and empty the floor in the future. Therefore, the plaster should be used to level the decoration and ensure the consistency of the materials.
3, on the line
With the improvement of living standards, the demand for household electricity is increasing. Complete replacement of electric wires is a point that can not be missed in second-hand housing renovation. Wiring must also be reasonable, as far as possible to consider all their equipment.
4, on the waterway
In this piece of waterway, in order to conceal the galvanized pipe, it is necessary to change the material, and the joint should be closed and closed. This concealment can be concealed.
5, on the waterproof
In the process of demolition, no one can guarantee that the waterproof layer will not be damaged. Therefore, the waterproof layer is a project that must be redone.
6, on the location of the lamp changes
The change in the position of the light is related to the structure of the past. Now when the position is changed, only a hole in the floor can be made. There is another hole in the side and the line is crossed. Don't push the wire, otherwise there is a potential safety hazard. .
7, on the outside window
The outer window of the year before 1995 was replaced as much as possible. It not only affected the appearance but also affected the loss of energy. It was not conducive to winter insulation and the use of air conditioning in summer.
Second-hand housing renovation experience talk Xuanguan renovation window home decoration cement house decoration new house
Dye intermediates mainly benzene intermediates, toluene intermediates, naphthalene intermediates and anthraquinone intermediates four categories, in addition, there are some heterocyclic intermediates. The main intermediates in the production of the reaction process are nitration, sulfonation, halogenation, reduction, amination, hydrolysis, oxidation, condensation and so on. Synthesis of a complex structure of the intermediate often go through many unit processes, sometimes using different basic raw materials and different synthetic routes. For example, the production of p-nitroaniline, the initial nitration with benzene, reduced aniline, re-acetylation, nitration, hydrolysis of the synthetic route, this method of long production process, high cost. Has now switched to benzene chlorination, nitration, separation of nitrochlorobenzene, and then high pressure ammonia solution synthesis route. For the manufacture of dyes, pesticides or Pharmaceutical Intermediates, usually complex structure, often supporting the final product and production, smaller production, production and more use of intermittent operation. Some of the most widely used intermediates, such as nitrobenzene, aniline, chlorobenzene, phenol, etc., are usually produced in a large, integrated chemical plant with large production volumes and continuous operation in production.
Dyestuff Intermediate,Methylbenzoyl Chloride,Naphthalenetetracarboxylic Acid,Acid Dyes Ethylbenzyltoluidine
SHANDONG ZHISHANG CHEMICAL CO.LTD , http://www.zhishangchemical.com