Also entered the decoration season, many owners and prospective owners have started the preparatory work for the renovation of new homes. What is lacking among those who first renovated is the “actual combat†experience. It is difficult to predict some problems that may arise during the renovation process. In view of this, various construction and quality problems that are likely to occur during the home improvement process will be matched with on-site photographs to vividly show the details of the decoration so that more users who will be renovated will be able to draw lessons.
1, wall and floor tiles without seam wall brick unpressed floor tiles
The lack of seams in the tiles results in excessive gaps between the tiles and corners. Another situation is that the wall tiles have not pressed the floor tiles, resulting in gaps at the junctions of the tiles. These conditions are caused by the low construction quality during the construction process.
Experts advise that the lack of joints between tiles and floor tiles results in excessive gaps between tiles and corners, which is a common problem in the decoration of homes. Although this situation can be post-repaired, it will result in unsightly joints between tiles.
The nozzles of the heating pipes were completely exposed before the heating was installed, and no corresponding protection was provided.
Experts advise: There are many materials on the construction site, and the nozzle of the heating pipe is not protected. Once a heavy object hits the heating nozzle, it is likely to cause deformation of the nozzle, leakage of water after installation, and damage to the floor.
2, wire private take over
When wiring wires for house renovation, casually connect wires.
Experts advise: To avoid these situations, the first is to ask an experienced electrician. Secondly, the plastic sheathing wires or other insulated conductors used in the wiring should be protected by pipes and cannot be buried directly in the cement or lime paint layer. Because the wire directly buried in the wall has been "dead" in the wall, it cannot be pulled out and it cannot be pulled. Once a section of the line is damaged, it needs to be replaced. Only the wall surface can be re-routed. When the line is changed, there must be no joint in the middle because the joint is directly buried in the wall. Over time, the insulation tape at the joint will be aged. Long-term buried in the wall will cause leakage. Therefore, it must not be in violation of the regulations and random wiring, so as to avoid accidents such as leakage.
3, damage to the wall does not change
Some holes can be seen on some bricks and broken, but the construction team is too cumbersome to replace them with new bricks.
Experts advise: Be careful when accepting the wall tiles, damaged brick wall should be replaced in time, so as not to affect the overall appearance of the wall.
4. Construction site violates construction safety regulations
In addition to finding that some of the heavy objects were piled up in a corner of the room, it was found that the construction ladders did not have any fixed measures, and that construction workers were still smoking while working on the construction site.
Experts advise: In order to protect the safety of construction personnel, the ladder should be fastened with a safety rope. The non-slip material on the foot of the ladder not only can avoid accidental injury such as falling people when working on a smooth surface, but also can effectively protect materials such as floor tiles or floor from wear. In addition, it should be emphasized that there are many materials on the construction site and smoking is strictly prohibited to prevent fires.
5, non-compliance with the norms of poor construction quality
There are many places that do not follow the rules, and the main ones are the gap between the door stone and the door frame. There is no gap between the wall tiles, and even a staggered seam occurs. The ceiling of the ceiling is too large, the edge is not straight, and the gap between the floor tile and the sliding door frame is too large and the angle between the yin and yang is not vertical.
Experts advise: Construction should be conducted in strict accordance with industry norms.
6, cut corners
Do not leave enough length when installing TV lines. The mouthwash material is replaced with scraps.
Experts advise: The length of the TV line is not enough to affect the use of electrical appliances after the stay; the mouthwash should be a whole piece of sheet, and should not exceed 2 pieces at most.
7, uncivilized construction site messy
Garbage some of the decoration debris or pour into the sewers, toilets and other places.
Experts advise: Do not pour waste, etc. into the toilet, which can easily lead to blockage of the sewer.
>>>Links: Don't Let Winter Regret Fill New Home
Home Furnishing Stuffed Experience Porcelain Decoration Heating TV Decoration Toilet Cement Appliances Floor Tiles Tile Rubber Floor Tiles
Ferrous Sulfate Co., Ltd. , http://www.nssulphate.com