Many people like to raise fish at home. Then, it is necessary to choose a beautiful fish tank. The fish tank lamp holder can also be hand-made by ourselves. So, how to make a fish tank lamp holder ? Let's take a look at go Introduction of Jiaju.com.
Detailed description of the homemade fish tank lamp holder:
The first step of the homemade fish tank lamp holder:
First, cut the 160mm PVC pipe into two halves. Don't mind if the two halves are equal, but cut it flat. See Sherman's cutting technique, then cut two 4-5mm wide lines on the PVC board. Subtract twice the thickness of the PVC end plate for the total length of the luminaire, which can be slightly shorter.
The second step of the self-made fish tank lamp holder:
The lines are glued with AB along the inner side of the lower side of the PVC pipe to hold the reflective paper. The PVC half pipe is pressed on the PVC board to draw a line, and then two end plates are cut out, and the end plate is opened according to the size of the fan, and the fixing screw hole is drilled.
The third step of the self-made fish tank lamp holder:
A plurality of cooling holes are opened by the electric drill above the PVC pipe, and then the aluminum plate of 12.5 mm width (the ready-made width, slightly larger and smaller, not much difference) is sawed into a suitable length, and the length is 3 cm shorter than the total length of the lamp.
The fourth step of the self-made fish tank lamp holder:
Then, according to the position of the lamp and the position of the rectifier, the corresponding holes are drilled. If a bolt of 3 mm diameter is used, a drill of 4 mm is used.
The fifth step of the self-made fish tank lamp holder:
The lamp holder can be removed from the rectifier first, and the hole position is also drilled in the aluminum plate, and the cut reflective paper is fixed on the aluminum plate together with the lamp holder, so that the aluminum plate is placed in the middle of the reflective paper, so that it is turned over and placed flat. At the time, the aluminum plate will remain at a basic level.
The sixth step of the self-made fish tank lamp holder:
The power module is attached to the aluminum plate with 3M tape and then adhered to the aluminum plate. The lamp is laid flat, and a mark is placed at a position slightly higher than the aluminum plate. Two holes are drilled horizontally for the support of the final aluminum plate.
The seventh step of the self-made fish tank lamp holder:
This work is done when the end plate is not fixed to the PVC pipe. The end plate is bonded with PVC with AB glue. Later, considering that the end plate cutting is not very close to the pipe wall, it needs to be smoothed with black rubber to prevent light leakage.
The self-made fish tank lamp holder explains the eighth step:
A stainless steel mesh is added to the fan to prevent ash and prevent accidental accidental contact with the fan blade. In addition, a small switch can be added near the fan, mainly considering the problem of heat dissipation in summer, and the lamp itself has no switch. After all, we all use timer switches.
How to make a self-made fish tank lamp holder is introduced here. The fan is preceded by a stainless steel mesh to prevent ash and prevent accidental accidental touch on the fan blade. In addition, a small switch can be added near the fan, mainly considering In the summer heat problem, the lamp itself does not have a switch. After all, we all use the timer switch. For more information, please stay tuned for the tracking report of Xiaojiaju.com.
Hex Bolts,Hex Head Flange Bolt,Stainless Steel Hex Bolt,Hexagon Hex Bolt
Taizhou Fengye Metal Products Co., Ltd. , https://www.fyhandware.com