The MMC equipment never lags behind in performance. High-quality hydraulic forming machines have been widely used in various regions of our country. The MDF has brought us more convenience and benefits, and the hydraulic system is mainly used. Applied to the pressing stage, the brick machine equipment needs the hydraulic system to have the extremely high quality, a little small shake will cause the quality problem to the finished product, therefore the hydraulic system of the hydraulic forming machine needs to carry on the maintenance and the maintenance strictly according to the specification. However, when the production time is too long, the hydraulic system will always have a high oil temperature. The following technical personnel from the Dongyue brick machine will introduce the control method for the oil temperature of the hydraulic system of the unburnt brick machine. , I hope you will help.
1. The normal working temperature is between 30°C~60°C and the maximum is no more than 85°C.
2. The tank should be kept clean and free of any debris. dust.
3. The fuel level of the fuel tank is in place as required.
4 The tank should be cleaned in time, cleaned one month after the new pump is put into use, and cleaned once every six months afterwards, that is, all crude oil will be released. The working environment must be free from dust and debris. After being precipitated for 24 hours, it shall be filtered through a 15 um filter, injected into a cleaned oil tank, and properly refueled. Never allow the contaminated bottom oil to fall back into the tank and the working environment must not contain dust.
5. The circulating water in the cooler should be sufficient. If it is found that the water leakage should be treated in time, the cooling water in winter should be released.
6. Always pay attention to the working conditions of the pressure gauge, solenoid valve and reversing valve, and find that the abnormality is resolved quickly.
1. The normal working temperature is between 30°C~60°C and the maximum is no more than 85°C.
2. The tank should be kept clean and free of any debris. dust.
3. The fuel level of the fuel tank is in place as required.
4 The tank should be cleaned in time, cleaned one month after the new pump is put into use, and cleaned once every six months afterwards, that is, all crude oil will be released. The working environment must be free from dust and debris. After being precipitated for 24 hours, it shall be filtered through a 15 um filter, injected into a cleaned oil tank, and properly refueled. Never allow the contaminated bottom oil to fall back into the tank and the working environment must not contain dust.
5. The circulating water in the cooler should be sufficient. If it is found that the water leakage should be treated in time, the cooling water in winter should be released.
6. Always pay attention to the working conditions of the pressure gauge, solenoid valve and reversing valve, and find that the abnormality is resolved quickly.
JINAN LODOR CNC EQUIPMENT CO.,LTD , https://www.zgfireplace.com