Epoxy floor engineering construction method epoxy floor engineering calculation rules


We will see the appearance of epoxy floor in large factories or parking lots. Its performance is very good, it not only protects the ground, but also plays a decorative effect, but people are working on the construction of epoxy floor. The calculation rules are not so well understood. The following is a small series of the decoration home network to introduce to you, what are the calculation rules for the epoxy floor engineering construction method and the epoxy floor engineering calculation.


环氧地坪工程


I. Epoxy floor construction method


1. Firstly, the base layer is treated, and the construction ground is completely ground with a slurry, and the defects on the ground are exposed. Then sweep the dust and debris, repair the holes, cracks, etc. with mortar and polish them. Where there is looseness, use it to be polished to compact. You can rinse the floor with water, but wait until the ground is completely dry before applying.


2. First make the primer layer, blend the epoxy resin and curing agent according to the corresponding proportions, stir evenly and then apply it to the ground with a scraper or shareholder. The effect of this layer is to enhance the adhesion between the ground and other coatings.


3. Wait until the bottom layer is dry and then apply the second layer. If it is a secondary coating, use the surface layer directly. The top layer is coated with two layers and a curing agent is also required. Apply evenly and smoothly. If it is a three-layer coating, then a medium coating is to be applied between the bottom layer and the top layer. In addition to the epoxy resin and curing agent, quartz sand is added. After the middle coating is applied, it should be smoothed.


4. After the construction is finished, the garbage on the site will be cleaned, but the outer fence can not be removed. After the epoxy floor is dried for 7 days, the outer fence can be removed and put into use.


环氧地坪工程


Second, the epoxy floor engineering calculation rules


1. The screed and the overall floor and the coating and the low-temperature radiation floor are calculated in square meters according to the clearance area between the main walls. The area occupied by the equipment foundation and indoor channel protruding from the ground shall be deducted, and the area occupied by the slabs, columns, wall-mounted chimneys and holes within 0.3 m2 shall not be deducted, but the area of ​​the heating trough, door opening and the opening of the niche shall also be No increase; where the leveling joint of the waterproofing mortar is flattened, and the height of the vertical wall is less than 50cm, the amount of work to be integrated into the ground according to the expanded area is calculated. The sub-heads of the current terrazzo floor, block surface layer, rhombohedral surface layer, anti-corrosion and acid-resistant surface layer, stone coating and curing liquid are calculated in units of square meters according to the actual area.


2. The area of ​​the room, the wooden floor and the plastic floor according to the room clearance between the main walls, calculated in square meters. The area occupied by the partition wall, the partition wall, the column raft, the wall-mounted chimney, etc., the door opening, the heating tank, etc. are not increased. The scissors support, flat support, and travel wood of the wooden mantle are included in the quota and are not calculated. The various surface layers of the stairs are calculated in square meters according to the horizontal projection area of ​​the stairwell. If the width of the stairwell is less than 50cm, the area shall not be deducted: if it exceeds 50cm, the area shall be deducted. The anti-slip strip, the pressure plate and the pressure stick are calculated in meters according to the actual length.


Epoxy floor is now used by people, and some playgrounds are often seen. So what are the construction methods and calculation rules for epoxy floor engineering? I think that for these problems, everyone has introduced the above small series. I understand that, if you still want to know more about decoration, please continue to pay attention to the decoration home Internet cafe.


More related wonderful reading:

What are the epoxy floor paints? Epoxy floor paint type

Acceptance criteria for curing epoxy floor of floor epoxy floor paint

Self-leveling epoxy floor interpretation self-leveling epoxy floor construction technology

Self-leveling epoxy floor paint features self-leveling epoxy floor paint price

Introduction of waterborne epoxy floor paint brand, introduction of floor paint characteristics

Furniture Handle

Furniture Handle,Exterior Door Handle,Nordic Brushed Gold Handle,Space Aluminum Alloy Handle

Guangzhou Junpai Hardware Co., Ltd , https://www.gdjhfurniture.com